Computer Networking Bootcamp Module 4 Quiz

On an Ethernet switched network, which type of address does a host computer use to communicate with another host within the same network segment?

Which of the following Ethernet standards can operate in full-duplex mode and achieve a total throughput of 200 Mbps over Category 5e (Cat5e) cabling?

In a collision domain, how many devices must listen when a single host is transmitting?

If you are using a cabling standard labeled 100Base-TF, what type of medium is being used?

Which protocol helps network devices share bandwidth and avoid simultaneous transmissions on an Ethernet medium?

What is the maximum cable distance for a 10GBase-SR Ethernet connection?

10GBase-SR is a 10 Gigabit Ethernet standard designed for short-range multimode fiber connections, supporting up to 100 meters over OM3 fiber.

In a 100Base-T Ethernet network operating in full-duplex mode, how many wire pairs are used?

What is the maximum distance supported by a 100GBase-LR Ethernet connection?

What is the effective throughput increase when switching from half-duplex to full-duplex communication?

Which of the following cannot use full-duplex communication?

Convert the following binary IP address to decimal format:

11000000.10101000.00110000.11110000

Which technology allows increased bandwidth by combining multiple physical connections into a single logical link?

How is the decimal number 10 represented in binary?

What is the decimal equivalent of the binary number 11101000?

What is the hexadecimal representation of the decimal number 10?

How many bits are in a MAC address?

What is the maximum cable length for a 1000Base-T (Gigabit Ethernet) connection?

In an Ethernet frame, what is the purpose of the Frame Check Sequence (FCS) field?

In the Ethernet standard 100Base-TX, what does the term Base represent?